ATARtools › Courses › Monash University › Mechanical Engineering (Honours)/Industrial Design
Mechanical Engineering (Honours)/Industrial Design at Monash University: ATAR needed
Clayton · December 2025 offer roundIn the December 2025 offer round the lowest selection rank to receive an offer for Mechanical Engineering (Honours)/Industrial Design at Monash University (Clayton) was 86.75 — up 0.45 from 86.30 in 2024. An ATAR of 86.75 means the last student offered a place was in about the top 13.25% of students in their age group.
The lowest selection rank is the lowest rank (your ATAR plus any adjustment factors) that received an offer in the December round. January rounds often go lower, so treat it as a guide to the selection standard, not a cut-off. VTAC course code 2800328671.
What it takes to reach 86.75Using VTAC's official aggregate to ATAR table.
You need an aggregate of about 147.8 (out of a possible 210): your best English plus three other scaled study scores, plus 10% of your fifth and sixth. If your scaled scores were all about equal, that is roughly 35.2 in each study.
Scaled scores depend on the study: see how each VCE subject scales, and use the calculator to estimate yours from SAC and exam marks.
Mechanical Engineering (Honours)/Industrial Design: 2024 to 2025
| December round | Lowest selection rank |
|---|---|
| 2024 | 86.30 |
| 2025 | 86.75 |
A rise means the course was harder to get into, a fall means easier — but a single round can move for many reasons (offers made, intake size, adjustment factors).
Other Monash University courses with a similar rank
Mechanical Engineering (Honours)/Industrial Design questions
What ATAR do I need for Mechanical Engineering (Honours)/Industrial Design at Monash University?
The lowest selection rank to receive an offer for Mechanical Engineering (Honours)/Industrial Design at Monash University (Clayton) in the December 2025 round was 86.75 — up 0.45 from 86.30 in 2024. That rank is your ATAR plus any adjustment factors, so you may need a little more or less than your ATAR alone.
Can I get into Mechanical Engineering (Honours)/Industrial Design at Monash University with a lower ATAR?
Possibly. The figure above is the lowest rank offered a place in the December round, and further offers are made in January. Many institutions also add adjustment factors (for example for disadvantage, or for subject results) and some have special entry schemes. Check VTAC CourseSearch for course code 2800328671 and the institution's own admissions page.